A3 Brace / Stock Tailhook Adapter

Builder Armory Tailhook Mount for A3 Brace Arms Run a GearheadWorks Tailhook on your A3 brace arm with a mount made for that pairing. It's 3D printed in-house and fits the A3 arm's profile, so the Tailhook sits tight and lined up with no wobble, rattle or makeshift shims. Features - Direct fit: Made to match the A3 brace arm and the Tailhook's mounting interface. No drilling or permanent changes. - Solid lockup:*Tight tolerances keep the Tailhook from shifting under recoil or while you handle the gun. - Engineering-grade material:Printed in [PETG / Nylon-CF / PA12 – specify] for strength, heat resistance and long life. - Low profile: Adds almost no bulk and keeps your setup clean. - Simple install: Uses [included / standard] hardware and goes on in minutes with basic hand tools. - Made in the USA: Designed, printed and checked by Builder Armory. What's included - (1) Tailhook mount for A3 brace arms - Mounting Hardware Compatibility - GearheadWorks Tailhook [Mod 1 / Mod 2 – specify] - A3 brace arms [list specific models/lengths] Please note: The GearheadWorks Tailhook and A3 brace arm are sold separately. This is an aftermarket accessory. Builder Armory is not affiliated with or endorsed by GearheadWorks. The buyer is responsible for following all federal, state and local laws on configuring firearms.